Power Switch/Led Assembly - HP 200 G1 Microtower Maintenance & Service Manual

Power switch/LED assembly

Description
Power switch/LED assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the optical drive
5. Disconnect the braided cables from the black system board connector labeled F_PANEL (1).
6. Remove the cable from the metal clip (2) built into the computer.
7. From the inside of the computer, push up on the tab on the bottom of the assembly (3) to
disengage it from the computer.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 28).
(Removing an optical drive on page
27).
39).
Power switch/LED assembly
Spare part number
667850-001
26).
43