Replacing an Optical Drive
To install an optical drive:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
If the new drive has screws installed on the sides of the drive, remove the screws before
inserting the drive into the chassis.
5.
Push the replacement disc drive partially into the drive bay in the computer.
Figure 2-31
6.
Connect the power cable (1) and data cable (2) to the rear of the optical drive.
Figure 2-32
(Access Panel on page
(Front Bezel on page
Installing the optical drive
Connecting the power and data cables
(Preparation for Disassembly on page
5).
7).
4).
Drives
27