1 Remove the front bezel. See "Removing and Replacing the Optional Front
Bezel" on page 81.
2 If a drive blank is present in the bay, remove it. See "Removing a Drive
Blank" on page 84.
3 Install the hot-swap hard drive.
Press the button on the front of the drive carrier.
a
Insert the hard-drive carrier into the drive bay until the carrier
b
contacts the backplane.
Close the handle to lock the drive in place.With the lever on the hard
c
drive carrier open, slide the hard drive into the drive bay until the
carrier contacts the backplane (see Figure 3-5).
Removing a Hard Drive From a Hard-Drive Carrier
Remove the screws from the slide rails on the hard-drive carrier and separate
the hard drive from the carrier. See Figure 3-6.
Installing System Components
87