Dell PowerEdge R410 Hardware Owner's Manual page 141

1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
3 Remove the system board shroud. See "Removing the System Board
Shroud" on page 105.
4 Remove all expansion cards and the integrated storage controller card. See
"Removing an Expansion Card" on page 99 and "Removing the Integrated
Storage Controller Card" on page 100.
5 Remove the expansion-card riser. See "Removing an Expansion-Card
Riser" on page 102.
6 Remove the processor heat sinks. See "Removing a Processor" on page 126.
7 If installed, remove the optional iDRAC6 Enterprise card. See "Removing
an iDRAC6 Enterprise Card" on page 111.
8 If installed, remove the optional iDRAC6 Express card. See "Removing an
iDRAC6 Express Card (Optional)" on page 108.
9 Disconnect all cables from the system board.
10 Remove the system board assembly:
Remove the nine screws securing the system board to the chassis
a
and then slide the system board assembly toward the front end of
the chassis.
CAUTION:
Do not lift the system board assembly by grasping a memory module,
processor, or other components.
Grasp the system board assembly by the edges of the system board and
b
lift the assembly away from the chassis. See Figure 3-29.
Installing System Components
141