Dell PowerEdge R410 Hardware Owner's Manual page 51

Table 1-3. System Messages (continued)
Message
Unable to launch
System Services
image. System
halted!
Unexpected
interrupt in
protected mode
Unsupported CPU
combination
Unsupported CPU
stepping
detected
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Causes
System halted after F10
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
The optional iDRAC6
Enterprise card flash memory
or BMC SPI flash may be
corrupted.
Improperly seated memory
modules or faulty
keyboard/mouse
controller chip.
Processor(s) is not supported
by the system.
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Corrective Actions
Restart the system and
update the Unified Server
Configurator repository to
the latest software to restore
full functionality. See the
Unified Server
Configuration user
documentation for
more information.
Restore the flash memory
using the latest version on
support.dell.com. See the
Integrated Dell™ Remote
Access Controller 6
(iDRAC6) User Guide for
instructions on performing a
field replacement of the
flash memory.
Reseat the memory modules.
See "Troubleshooting
System Memory" on
page 152. If the problem
persists, see "Getting Help"
on page 167.
Install a supported processor
or processor combination.
See "Processors" on
page 126.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 119.
About Your System
51