Gastroback DESIGN MULTI JUICER DIGITAL PRO Operating Instructions Manual page 56

Problem Reason The Solution
During operation, a This may occur duri- There is no need for concern. However, if the problem persists
slightly burnt smell ng the first run of even after repeated usage, get in contact with an authorized
is escaping from the the motor and usual- service centre.
appliance. ly stops after some
time of operation.
During operation, loops Immediately unplug the appliance. Always unwind the power
of the power cord cord completely (approx. 110cm) to avoid overheating. Check
have been still wound the complete power cord for damage (e.g. molten or brittle
around the cord sto- parts, discolouration). If in doubt, get in contact with an authori-
rage at the bottom of sed service centre for examination and repair.
the motor base.
Liquids ran into the Immediately switch off (selection dial to "OFF", power switch
motor base. to "O") and unplug. Clean the appliance and leave the appli-
ance dry naturally for at least 1 day. If the problem persists, get
in contact with an authorized service centre.
The motor is over- Leave the appliance cool down for at least 1/2 hour.
heated.
110
Problem Reason The Solution
The display is illu- The processing sys- Ensure to install the processing system completely and correctly
minated, showing a tem is not installed (see: 'Assembling the Juicing System', 'Assembling the Mixing
speed selection, but correctly. For your Jug' or 'Assembling the Grinding System'). Systems for Mixing
the motor does not safety, the safety and Grinding: in most cases the thread between blade assembly
respond. interlocks prevent and glass container is not screwed on sufficiently tight, or the
operation. system is not locked correctly to the motor base. Perhaps, the
sealing ring is missing.
The overheat protec- Turn the selection dial to "OFF", switch off at the power switch,
tion device has been and unplug the appliance (see: 'Self-Resetting Overheat Protec-
triggered. tion Device'). Leave the appliance cool down for at least 1/2
hour. Do not let the appliance operate continuously for a too
long time (see: 'Method of Operation and Making Breaks').
The motor has been Turn the selection dial to "OFF", switch off at the power switch,
stalled for more than and unplug the appliance. Remove the obstacle. Thereafter, you
10 seconds. The may start operation again.
overload protection
has been triggered.
The automatic shut- After leaving the appliance in operational mode for more then
off has been trig- 20 minutes, the automatic shut-off is activated. Simply turn the
gered. selection dial to another speed selection to re-activate the appli-
ance (see: 'Automatic Shut-Off'). We strongly recommend to
leave the appliance cool down for approx. 20 minutes.
From the start on, This may appear Depending on the load that is straining the motor, regularly
the motor seems to during operation. make breaks every 7-20 minutes to avoid overheating (see:
run with an uneven 'Method of Operation and Making Breaks').
speed.
The appliance is With a large amount of hard, glutinous, or fibrous food and/
operated on heavy or large, hard pieces of food, the motor is strained with hea-
load. vy load. After max. 7 minutes of continuous operation, make
a break of 20 minutes to avoid overheating (see: 'Method of
Operation and Making Breaks').
111