Gastroback DESIGN MULTI JUICER DIGITAL PRO Operating Instructions Manual page 38

• The glass containers of thesystems for mixing and grinding are fra-
gile. Do not expose the glass containers to extreme temperature
variations or excessive mechanical strain. Do not place the glass
containers on hot surfaces (e.g. oven or stove). Do not pour hot
liquids into the glass containers. Ensure that the glass containers
will not be chipped or fall or roll down from the table or counter.
To avoid severe injuries due to splinters or shards and damage
caused by leakage, do not use a glass container any more, when
it is damaged in any way (e.g. cracks, chipped edges) or has been
subject to inadmissible strain (e.g. mechanical shock, extreme tem-
perature variation).
• Always grasp the appliance at the motor base for moving it. Do not
hold the appliance at the locking arm, drive rotor, power cord, or
mounted processing system for moving the appliance. The locking
arm is part of the safety interlocks of the appliance and NOT inten-
ded as a handle for moving the appliance. Do not place any hard
and/or heavy objects on or in the appliance or any part of it. Take
care that no one will pull the appliance by the power cord.
• Operate the appliance on a well accessible, stable, level, clean, dry,
and suitable large table or counter that is resistant against fat and
water. Always wipe off spilled liquids immediately.
• Always keep the appliance and its parts in sufficient distance to the
edge of the table or counter and to other objects. Due to vibrations,
the appliance could move around during operation. Thus, close
supervision is necessary during operation! For operation, leave at
least 1m of free space above the motor base and at least 30cm of
free space on each side, to avoid damage due to splashes and ena-
ble unhindered handling.
• Do not place any clothes or tissue or other foreign objects under or
on the appliance during operation, to avoid risk of fire, electric shock
and overheating. The ventilation slits in the bottom of the motor base
may not be blocked. For operation, do not place the appliance over
a power cord or on metal surfaces (e.g. sink or drain board).
• This Appliance can be used by persons with reduced physical, sen-
sory or mental capabilities or lack of experience and knowledge if
74
they have been given supervision or instruction concerning use of the
appliance in a safe way and if they understand the hazards involved.
• Children may not play with appliance.
• This appliance shall not be used by children. Keep the appliance and
its cord out of reach of children.
• Always disconnect the appliance from the power supply if it is left
unattended and before assembling, disassembling, or cleaning.
• Do not place the appliance or any part of it on or near hot surfaces (e.g.
burner, heater, or oven). Do not place or immerse the appliance or any
part of it in hot liquids. Do not heat any parts or accessories of the
appliance via any sources of heat (e.g. range, fire, oven, microwave).
Do not fill in any hot food or hot beverages. When adding ingredients
during operation, do not leave liquids run down at the exterior of the
appliance. Always wipe off spilled liquids immediately. The appliance
is designed for processing edible food. Do not fill in any other material
or foreign objects, to avoid injuries and damage due to fire, electric
shock, and over-heating. Always observe the appropriate filling levels
to avoid overflow and damage (see: 'Technical Specifications').
• Always completely remove any extremely hard and inedible parts of
fruit and vegetables, before processing (i.e. nut shells, stones, bones).
Splinters of extremely hard parts could be sharp-edged and cause
severe injuries, when getting into your food. Additionally, extremely
hard parts damage the surfaces of the appliance. Do not operate the
appliance continuously for more than 20 minutes (normal load) and/or
no longer than 7 minutes (high load) to avoid overheating and for ensu-
ring a prolonged working life. After the corresponding time of continu-
ous operation, make a break of approx. 20 minutes (see: 'Method of
Operation and Making Breaks'). For juicing: Before operating the juicing
system, ensure that the drip-stop of the juice spout is turned to the open
position (small black handle is facing towards you). To avoid overflow
of the juice collector and blockage during juicing, ensure that the juices
are running into the juice jug without obstacles (e.g. deposits of fibres in
the juice collector) and the pulp is falling easily and freely into the pulp
container. Do not overfill the juice jug or pulp container.
75