Bridge Battery; Bridge Battery On Hard Disk Housing - NEC VERSA P Service Manual

4-26 Troubleshooting and Repair

Bridge Battery

Use the following steps to remove the bridge battery (see Figure Section 4-17).
1. Turn off the system power. Remove the battery and/or AC adapter if connected.
Remove the following as previously described:
2.
n
LCD
n
keyboard
n
hard disk drive.
Disconnect the bridge battery connector (P11) from the system board.
3.
4. Tip the hard disk housing and lift it out of the chassis.
5. The bridge battery is secured on the side of the hard disk housing with double-
sided tape. Peel bridge battery off of the hard disk housing.
Figure Section 4-17
P11

Bridge Battery on Hard Disk Housing

Bridge
Battery