Parallel Printer - NEC VERSA P Service Manual

Follow the instructions provided with each optional PCMCIA card.

PARALLEL PRINTER

Use the following steps to attach a parallel printer to the system using a parallel printer ca-
ble and the system's 25-pin connector.
1. Check that the system and printer power are turned off.
2. Press the left rear cover latch and open the left rear cover of the system.
Connect the 25-pin parallel printer cable connector to the printer port on the sys-
3.
tem.
Attach the 36-pin printer cable connector to the parallel port on the printer.
4.
Secure the printer cable with the screws. Use the connector clips to fasten the
5.
connector to the printer.
6. Connect the power cable to the printer. Plug the power cable into an outlet.
Connector
Clips
Figure Section 3-3
Screws
Printer Connection
Options 3-19