Disassembly And Reassembly; Versa P Series Disassembly Sequence - NEC VERSA P Service Manual

4-12 Troubleshooting and Repair

DISASSEMBLY AND REASSEMBLY

This subsection contains step-by-step disassembly procedures for the system. Reassembly is
the reverse of disassembly. Each procedure is supported by a simplified disassembly illus-
tration to facilitate removal. The detailed exploded-view diagram and parts lists for the sys-
tem unit are shown later in this subsection.
Required tools include a Phillips-head screwdriver. For complete disassembly of the system
unit, follow the disassembly order listed in Table Section 4-5 to reassemble, follow the table
in reverse order.
Table Section 4-5 Versa P Series Disassembly Sequence
Sequence
1
2
3
4
5
6
7
8
9
10
11
12
13
When disassembling the system unit, follow these general rules.
n
Turn off and disconnect all power and all options, including the AC adapter (if
connected) and primary battery pack (see the procedures that follow).
n
Do not disassemble the system into parts that are smaller than those specified in
the procedure.
n
Label all removed connectors. Note where the connector goes and in what posi-
tion it was installed.
Part
Primary Battery Pack (NiMH Battery)
Memory Card
Hard Disk Drive
LCD
Top Cover
Keyboard
LCD Indicator Panel
Diskette Drive
CMOS Battery
CPU Board
Bridge Battery
VersaTrack Assembly
System Board
See Page
4-13
4-14
4-15
4-17
4-19
4-19
4-21
4-22
4-24
4-25
4-26
4-27
4-28