NEC VERSA P Service Manual page 63

2-24 Setup and Operation
This procedure installs the previously saved BIOS in the system. Selecting this function dis-
plays a message similar to the following.
This procedure may require 10 to 60 seconds. A continuous sound pattern means a failure.
The utility restores the previous BIOS and resets the system to make the previous version
operational. To reuse the utility, power the system off and back on again with the BIOS
Update Utility diskette inserted in drive A.
Exit
This option exits the utility and resets the system. Press Esc to return to the Main Menu.
Press Enter to exit the utility.
Prevent unauthorized access to the BIOS by disabling the BIOS reprogramming. This pre-
vents any modification of the BIOS. The BIOS reprogramming is prevented by setting the
system's four-position DIP switch (SW1-1) to the ON position,
For detailed information on the dip switch, refer to "Operating Controls" in the beginning of
this section. Figure Section 2-3 shows the switch location.
This procedure installs the previously
saved BIOS in your computer.
After the new BIOS is restored, your
system is reset.
Enter "Y" to continue [N]
Warning: Do NOT disturb the system
while the restore procedure is in
progress.