Power Supply
Table Section 5-3 lists the Docking Station II power supply requirements.
Characteristic
Input Voltage (nominal)
Frequency
Output Voltage
Use the following steps to remove the power supply.
1.
Remove the following as previously described:
n
CRT base (if installed)
n
top cover
n
interface board.
Remove the two screws on the Docking Station II's rear panel.
2.
Figure Section 5-17 Power Supply Screws (Rear Panel)
Troubleshooting and Options for the Docking Station II
Table Section 5-3 Power Supply Requirements
Power Supply
Screws
Specification
100 to 240-V, Autosensing/Autoswitching
50/60 Hz
+5V (7.3 A maximum)
-5V (0.1 A maximum)
+12V (8.0 A maximum)
-12V (0.3 A maximum)
+12VCHG (2.5 A maximum)
+5V (0.3 A maximum)
5-15