Docking Station Ii Connection - NEC VERSA P Service Manual

2. Check that the right rear cover is completely open. Slide the cover underneath the
expansion port.
3. Place the system on the Docking Station II and carefully align the Docking Sta-
tion II's connector with the system's rear cover.
Figure Section 3-2
Firmly press the system into the Docking Station II's connector.
4.
5. Place the key in the Docking Station II's lock and turn it clockwise to lock the
system securely in place.
6. Attach one end of the Docking Station II's power cable to the Docking Station II,
and attach the other end to a properly grounded 100 to 240 VAC 50/60 Hz.
To remove the Docking Station II, use the steps below.
1. Turn the key to unlock the Versa lock on the Docking Station II.
Check the PCMCIA port cover on the side of the system and make sure it is se-
2.
curely closed.
Pull the Versa release lever towards the front of the Docking Station II.
3.
4. Pull the system forward and away from the Docking Station II.
NOTE: When the Docking Station II is attached
to the Versa P, the system's power switch is de-
activated. Power to the system is controlled us-
ing the Docking Station II's power switch.

Docking Station II Connection

Options 3-23