Docking The Nec Versa - NEC VERSA DOCK Service Manual

Use the following steps to dock your NEC Versa.
1. Locate the height lever on the left side of the unit.
A - Height lever position II B - Height lever position I
1. Set the height lever on the side of the NEC Versa Dock to match your
system as follows:
It is important that the height lever is set to the correct
height for system docking. The NEC Versa Dock will not
properly dock the NEC Versa if the height lever is set
incorrectly, which may result in system damage to either the
NEC Versa Dock or the NEC Versa. The Docking LED blinks
amber if the height lever is set incorrectly.
n
If you have an NEC Versa LX, set the lever to I by sliding the lever to
the front.
n
If you have an NEC Versa SX, set the lever to II by sliding the lever to
the rear.
3. Verify that the keylock switch is in the "Normal" position.
2-12 System Configuration and Setup
Locating the height lever
Keylock switch in the Normal position