Running The Acu For The Ultralite Versa, Versa E, And Versa P - NEC VERSA MEDIADOCK Service Manual

2-12 Setup and Operation
4. From the main ACU screen, press
From the Disk Drive Settings screen, press the down arrow or
5.
sor to the selection arrow next to "IDE Hard Disk Interface."
Press . Four options appear.
6. Alt-
7. Use the cursor down arrow to select "Internal/Docking Station" and press
8. Press Ente
r
Press X .
9. Select "Exit and Save Changes" and press
update your system.
To continue, go to "Start-Up Diskette Creation" later in this section.

Running the ACU for the UltraLite Versa, Versa E, and Versa P

Follow these steps to run the ACU for the UltraLite Versa, Versa E, and Versa P.
Connect the MediaDock to the AC adapter and an outlet, and dock the Versa.
1.
Power on and boot up the Versa.
2.
When the cursor changes to a blinking block, press
3.
4. From the main ACU screen, press
5. From the Disk Drive Settings screen, press the down arrow or
sor to the selection arrow next to "IDE Hard Disk Interface."
Press . Four options appear.
6. Alt-
Use the cursor down arrow to select "Internal/Docking Station" and press
7.
8. Press Enter
Press X .
9. Select "Exit and Save Changes" and press
update your system. To continue, go to the next section.
CAUTION: Disable power management through
the ACU when using the Versa V. If power man-
agement features are enabled and the system is
not used for the established time-out periods, the
Versa V goes into Sleep mode. When the Versa
V is docked on the MediaDock and enters Sleep
mode, the system locks up.
again to exit the Drive menu and return to the main ACU screen.
again to exit the Drive menu and return to the main ACU screen.
D to access the Drives menu.
Enter . Press Enter
to access the ACU.
F1
D to access the Drives menu.
Enter . Press Enter
to move the cur-
i
Enter .
at the prompt to
i to move the cur-
.
Enter
at the prompt to