Docking Connector Board, Pci Housing, And Power Supply - NEC VERSA DOCK Service Manual

4. Place docking height lever in position #II, turn keylock to the locked
position and remove key.
Use care to when removing or replacing plastic parts as the
locking tabs can be broken if forced.
Press down at the top cover notches and separate the side covers from the
5.
top cover, tilt outward and lift from the notches on the base of the Versa
Dock.
6. Slide the top cover forward, then tilt the top cover forward and past the
docking pins, when clear of the docking pins, lift and remove.

Docking Connector Board, PCI Housing, and Power Supply

Remove the docking connector board, PCI card and expansion bay assembly as
follows:
Remove two screws (
1.
3-10 Disassembly and Reassembly
Top cover screws
) on the left side.
A
Left side