NEC VERSA DOCK Service Manual page 55

6. Firmly push against the card until the connection is secure. If internal SCSI
devices are being installed, the device cable(s) must be routed from the PCI
card to the file bays. Feed one end of the cable through the left side of the
back of the unit and gently pull it toward to the back of the SCSI device.
Connect to the SCSI device and the card.
7. Replace the slot cover screw to secure the card.
A- Slot cover screw
7. Attach device cables to the installed PCI card.
8. Replace the back cover of the NEC Versa Dock and secure it with the two
screws.
9. Reconnect the power cable.
Using PCI Cards
When using PCI cards, it is important that you check that the device is not
enabled in all configurations in the Device Manager. You can check this by
using the following procedure.
1. After installing the PCI card and drivers, click Start, Settings, and Control
Panel.
2. Double click System.
3. Click the Device Manager tab. Select the card type from the list, highlight
the PCI card, and click Properties.
4. Under the General tab, make sure the box "Exists in all hardware profiles" is
not checked. If it is checked, remove the check.
Securing the card
System Configuration and Setup 2-39