NEC VERSA DOCK Service Manual page 39

Removing Trays, Panels, and Covers
Before installing a device in one of the NEC Versa Dock file bays, you must
remove the docking tray, front panel, and cable cover. Do so as follows:
1. Unplug the NEC Versa Dock, disconnect any peripheral devices that are
attached, and undock the NEC Versa if it is docked.
1. Disconnect any external cables that might be attached on an installed PCI
board (such as a network board).
3. Turn the keylock switch to the Manual position to disengage the motor
mechanism.
4. Remove the front part of the docking tray. First locate and remove the
rubber pads securing the three screws, then loosen and remove the three
screws. Lift the docking tray up and off the NEC Versa Dock.
Keylock switch in the Manual position
Removing the docking tray
System Configuration and Setup 2-23