NEC VERSA DOCK Service Manual page 68

Required Tools and Equipment
All NEC Versa Dock corrective maintenance procedures can be performed
using the following tools:
n
Key for the Versa Dock
n
Tweezers
n
Small flat-head screwdriver
n
Phillips screwdriver ( #1 ) with a 6-inch shaft
n
Right-angled dentist style probe.
Disassembly
This section contains step-by-step disassembly procedures for the system.
Reassembly is the reverse of disassembly. Each procedure is supported by a
simplified disassembly illustration to facilitate removal. These illustrations show
various items with callouts. A sub-assembly or part that was removed in a prior
step may be shown in the illustration. The illustration and callouts are accurate
for the described disassembly step.
The Illustrated Parts Breakdown and parts lists for the system unit are shown in
Section 5.
For complete disassembly of the Versa Dock, follow the disassembly order
listed below. To reassemble, follow the table in reverse order.
Level of
Disassembly
1
2
3
4
5
6
When disassembling the system unit, follow these general rules.
n
Do not disassemble the system into parts that are smaller than those
specified in the procedure.
3-2 Disassembly and Reassembly
NEC Versa Dock Disassembly Sequence
Components Available at Level of
Disassembly
Trays, Panels, and Covers
Disconnecting the Cables from the
Motherboard
Back Cover, Left and Right Sides, and Top
Cover
PCI Card and Expansion Bay Assembly
Table Assembly
Base Assembly (Main Board, LED Indicator
Board, and Power Supply)