NEC VERSA DOCK Service Manual page 44

Locating and connecting the cables to the IDE device
A - Audio cable port B - IDE signal cable port C - Power cable port
D - Power cable E - IDE signal cable F- Audio cable
3. Connect the appropriate power cable, the IDE signal cable, and if necessary
the audio cable to the ports on the back of the IDE device. The IDE cable
must be installed with the red stripe to the left side of the device.
4. Ensure that the IDE connector pin is oriented correctly on the IDE signal
cable.
If the power cable for the device you are installing uses a
small connector, use one of the cables provided in the
accessory kit.
You are now ready to install the IDE device into the file bay. (See the
instructions in "File Bay Installation" for details.)
2-28 System Configuration and Setup