NEC VERSA DOCK Service Manual page 59

1. Check that the docked NEC Versa is powered off and the monitor power
switch is turned off.
The docked NEC Versa must be powered off while the
monitor is being connected or the system does not
recognize the monitor type.
2. Position the monitor as follows:
n
To use the monitor without the monitor stand, simply place the monitor
on a flat surface next to the NEC Versa Dock.
n
To use the monitor stand
Close the LCD panel on the NEC Versa.
Lower the monitor stand onto the NEC Versa Dock.
Carefully center the external monitor on the monitor base.
Lowering the monitor base into place
System Configuration and Setup 2-43