Table of Contents
Advertisement
Diskette Drive Signal Cable
A two-connector diskette drive signal cable comes attached to
the riser board and to the standard 1.44-MB diskette drive.
The colored edge of the cable goes to pin 1 on the cable
connector. Align the red edge of the cable with pin 1 (the
notched end) on the drive connector.
The following figure shows a typical two-connector diskette
drive signal cable.
Diskette drive signal cable
A – Connects to 1.44-MB Diskette Drive (or other compatible device)
B – Connects to Riser Board
Installing Options 5-31
Advertisement
Table of Contents
