Boot Questions - NEC POWERMATE 5100 Manual

Hide thumbs Also See for POWERMATE 5100:
Table of Contents

Advertisement

Boot Questions

What is the meaning of the boot message that appears
when I turn on the computer?
Boot messages, such as "Escape to view POST, F2 to enter
BIOS Setup," or "Press F2 to run SETUP," indicate the
following startup options:
T
Wait while the system loads the operating system.
T
Press
while the boot message is displayed to view the
Esc
Power-On Self-Test (POST). The POST routine performs
diagnostic tests of the hardware at power-on.
T
Press
(or
F2
boot message) while the boot message is displayed to run
the BIOS Setup utility and view/change system
parameters.
Note:
options vary from system to system.
Why did I get the message "operating system not
found?"
If you left a CD in the CD-ROM drive, your system may not
be able to boot. Try removing the CD and rebooting.
Why did I get the message "non-system disk installed in
drive A?"
If you left a non-operating system diskette in the diskette
drive, your system may not be able to boot. Remove the
diskette (if present) and press any key. The boot should
proceed normally.
C-2 Questions and Answers
, depending on your system and the specific
F1
The actual boot message and view

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powermate 5100 series

Table of Contents