Table of Contents
Advertisement
For a description of the system configuration jumper settings,
see the following table.
System Configuration Jumper Settings
Jumper Position
Setting
Normal mode
Configure Mode
Recovery Mode
Verifying the Processor Speed
To verify that the system is set to operate at the speed of the
installed processor (266-MHz, 300-MHz, or 333-MHz,
depending on the system) in the BIOS Setup utility, the
system must be jumpered for Configure mode. In this mode,
the system enters the Maintenance menu when it is restarted.
To verify the processor speed, use the following steps.
NEC CSD recommends using needle-nose pliers to move a
jumper.
3-56 Configuring the System
Description
Factory setting. Sets the system for
normal operation. The BIOS uses the
current configuration information and
passwords for booting.
Allows system configuration. After
POST runs, the Setup utility loads
automatically. The Maintenance
menu appears for setting
configuration parameters (including
processor speed and password
settings).
Enables BIOS recovery procedures.
The BIOS attempts to recover the
BIOS configuration. A Recovery
diskette is required (downloadable
from the NEC CSD website).
Advertisement
Table of Contents
