Table of Contents
Advertisement
! CAUTION
Jumpers are set correctly at the factory for the
system configuration. Only check (or change) the
appropriate jumper setting if you notice that a
processor speed mismatch appears when you
turn on the system (during the power-on self-
test). Otherwise, keep the jumpers at their factory
settings.
Access the BIOS Setup utility and record your customized
settings. See "BIOS Setup Utility."
! CAUTION
Starting the system in Configure mode resets
BIOS settings to their factory defaults.
Before jumpering the system for Configure mode,
write down any customized BIOS settings. When
the system is started in Normal mode, press
to bring up the BIOS Setup utility. Re-customize
your BIOS settings.
1. Power off and unplug the system and any external
options. Remove the system unit cover (see "Removing
the Cover").
!
The system power must be off before changing a
jumper setting.
2. Locate the J6C1 jumper block on the system board (see
"System Board Jumper Settings").
WARNING
Configuring the System 3-57
F2
Advertisement
Table of Contents
