Table of Contents
Advertisement
System board cable connectors
Diskette Drive Signal Cable
A three-connector diskette drive signal cable comes attached
to the system board and to the standard 1.44-MB diskette
drive.
The installation of a second diskette drive in your system
does not require the replacement of the existing diskette
drive signal cable. Connect an optional diskette drive to the
middle connector on the standard diskette drive signal cable.
The colored edge of the cable goes to pin 1 on the cable
connector. Align the red edge of the cable with pin 1 (the
notched end) on the drive connector.
The following figure shows a three-connector diskette drive
signal cable.
Installing Options 5-27
Advertisement
Table of Contents
