Invertek Drives elevator CORE Quick Start-Up Manual page 57

57 | P a g e
Display No. Description
message
Drive is being powered from the

- USB_C port on the front of the
drive.
Drive is being powered from the
USB_C port on the front of the

-
drive and data transmitting via
USB_C is disabled (P2-13 set to 0)
Save User defaults action has

-
been performed
Clear User defaults action has

-
been performed

18 4-20mA Signal Lost
 Current input >25mA
28
20.3. ncoder odule Status L
LED
Top LED
Bottom LED
Corrective Action/Further information
Shown when P11-01 is set to 1 to save values as user default parameters.
Shown when P11-01 is set to 2 to clear user default parameters.
The reference signal on Analog Input 1 or 2 (DI4/DI5) has dropped below the minimum
threshold of 3mA. Check the signal source and wiring to the drive terminals.
Reduce current to maximum of 20mA on terminals DI4/DI5
's .
Function Indication
Red = Power on
Power Status
Off = No power
Off = No Error
Green = No Signal
Error Status
connected/received
Green Flashing = Error
www.InvertekDrives.com