CanyCom CG 101 Operator's Manual page 74

6
Area
Cutting blade cuts into
ground.
Cutter load is too high.
Cutting
System
Nimber of scatter
objects are increased
Cutting rotor does
not move when
cutting rotor clutch is
operated.
Cutting rotor does
not stop when
cutting rotor clutch is
disengaged.
Troubleshooting
Malfunction
Cutting height is too low. →Raise cutting height.
Machine turns too fast.
Work site has
undulations.
Cutting blade (knives
or stay) is bent.
Engine speed is too low. →Raise engine speed.
Driving speed is too
high.
Cutting blades are
worn out.
Cut grass or vines
are tangled to cutting
blade axle.
Handle lever height is
not properly adjusted.
Antiscattering cover is
damaged.
Cutting height is too
low.
Many foreign objects,
such as waste cans are
exist in the work site.
V- belt is wear out.
V-belt is too loose.
Cutting rotor clutch
wire is not adjusted
properly.
Brake shoe is wear
out.
Possible Cause
→Turn slowly.
→Raise cutting height.
→Replace.
→Drive slow.
→Replace.
→Untangle.
→Adjust height
→Replace.
→Raise cutting height.
→Remove foreign
→Replace.
→Adjust cutting rotor
→Adjust wire properly.
→Please contact
-64-
Corrective Measure
propelry.
objects before
working.
or V-belt for rotor
properly.
your CANYCOM
representative.
Ref.
Page 48
Page 49
Pages
50, 52
Pages
50, 52
Page 50