S&C IntelliRupter PulseCloser Configuration Manual page 3

Special Warranty
Provisions
The standard warranty contained in S&C's standard conditions of sale, as set forth in Price
Sheets 150 and 181, applies to the IntelliRupter fault interrupter, except the first paragraph
of the said warranty is replaced by the following:
(1) General: The seller warrants to the immediate purchaser or end user for a period of
10 years from the date of shipment that the equipment delivered will be of the kind
and quality specified in the contract description and will be free of defects of work-
manship and material. Should any failure to conform to this warranty appear under
proper and normal use within 10 years after the date of shipment, the seller agrees,
upon prompt notification thereof and confirmation the equipment has been stored,
installed, operated, inspected, and maintained in accordance with the recommen-
dations of the seller and standard industry practice, to correct the nonconformity
either by repairing any damaged or defective parts of the equipment or (at the seller's
option) by shipment of necessary replacement parts. The seller's warranty does not
apply to any equipment that has been disassembled, repaired, or altered by anyone
other than the seller. This limited warranty is granted only to the immediate purchaser
or, if the equipment is purchased by a third party for installation in third-party equip-
ment, the end user of the equipment. The seller's duty to perform under any warranty
may be delayed, at the seller's sole option, until the seller has been paid in full for
all goods purchased by the immediate purchaser. No such delay shall extend the
warranty period.
Replacement parts provided by the seller or repairs performed by the seller under
the warranty for the original equipment will be covered by the above
special warranty provision for its duration. Replacement parts purchased
separately will be covered by the above special warranty provision.
For equipment/services packages, the seller warrants for a period of one year
after commissioning that the IntelliRupter fault interrupter will provide automatic
fault isolation and system reconfiguration per agreed-upon service levels. The remedy
shall be additional system analysis and reconfiguration of the
IntelliTeam® SG Automatic Restoration System until the desired result is achieved.
Warranty of the IntelliRupter fault interrupter is contingent upon the installation,
configuration, and use of the control or software in accordance with S&C's applicable
instruction sheets.
This warranty does not apply to major components not of S&C manufacture, such
as batteries and communication devices. However, S&C will assign to immediate
purchaser or end user all manufacturer's warranties that apply to such major
components.
Warranty of equipment/services packages is contingent upon receipt of adequate
information on the user's distribution system, sufficiently detailed to prepare a
technical analysis. The seller is not liable if an act of nature or parties beyond S&C's
control negatively impact performance of equipment/services packages; for example,
new construction that impedes radio communication, or changes to the distribution
system that impact protection systems, available fault currents, or system-loading
characteristics.
Introduction
. S&C Instruction Sheet 766-526 3