S&C IntelliRupter PulseCloser Configuration Manual page 13

Setting the R3 Communication Module to Ethernet IP Configuration
NOTICE
Proper grounding with a wrist strap connected to
ground is required when touching any components
within the communication module or contacts on
the R3 Communication Module connector .
The R3 Communication Module is shipped from the
factory with a serial communication configuration. See
the wiring diagram in Figure 41 on page 23.
This section instructs configuring the module to
use the Ethernet IP configuration, which allows remote
access to the Wi-Fi/GPS user interface, enables remote
firmware updates, and allows use of advanced security
features available in the R3 Communication Module
firmware version 3.0.00512. See the wiring diagram in
Figure 42 on page 24.
To configure the R3 Communication Module for
Ethernet IP wiring, WAN traffic must be routed through
the Wi-Fi/GPS module. Follow these steps to convert
the R3 Communication Module from the serial commu-
nication configuration wiring to the IP configuration
module wiring:
At the communication device, unplug the RJ45
STEP 1 .
cable that runs between the communication
device and the control module. See Figure 14
on page 11.
At the Wi-Fi/GPS module, plug the RJ45 cable
STEP 2 .
from the control into Ethernet 1 on the Wi-Fi/
GPS module. See Figure 18.
Locate the Ethernet patch cord provided with
STEP 3 .
the R3 Communication Module and plug one
end into Ethernet 2 on the Wi-Fi/GPS module
and the other into the Ethernet port on the
communication device. See Figure 19.
Install the DB-9 cable to the field communica-
STEP 4 .
tion device so Wi-Fi can communicate with that
device. See S&C Instruction Sheet 766-528 with
module firmware version 3.0.00512 or Instruc-
tion Sheet 766-524 for other firmware versions.
See Figure 19.
Ethernet 1
Figure 18 . The RJ45 cable from the control plugged into
Ethernet 1 .
Figure 19 . The Ethernet patch cord plugged into
Ethernet 2 .
. S&C Instruction Sheet 766-526
Ethernet 2
DB-9 cable to
comm device
13