Transmitting Synchronization Messages (Clock Out); Using Program Change Messages To Switch Setups (Setup Control Channel); Setting The Device Id Number (Device Id); Selecting The Usb Driver (Usb Driver) - Roland RD-700GX Owner's Manual

Detailed Settings for Each Function ([EDIT] Button)
Transmitting Synchronization
Messages (Clock Out)
This setting determines whether or not the MIDI messages
necessary to synchronize the RD-700GX with external devices
are to be transmitted from the MIDI OUT connector.
Parameter
Clock Out
Using Program Change Messages to
Switch Setups (SETUP Control Channel)
You can switch the RD-700GX's Setups with MIDI messages
from an external MIDI device.
Set the MIDI Receive channel for receiving the MIDI messages
(Program Changes) from the external MIDI device to be used
for switching Setups.
When not switching Setups from an external MIDI device, set
this to OFF.
Parameter
SETUP Ctrl Ch
(SETUP Control Channel)
When the SETUP Control Channel settings are
transmitted along with the part's MIDI receive
channel (p. 127), switching of Setups takes priority
NOTE
over the switching of tones.
For more information about Switching Setups, refer
to "Switching Setups" (p. 140).
Setting the Device ID Number
(Device ID)
The Device ID number is an identification number used when
transmitting and receiving MIDI Exclusive messages. When
transmitting Exclusive messages, the device ID numbers of the
corresponding devices must be matched.
Parameter
Device ID
110
Value
ON, OFF
Value
1–16, OFF
Value
17–32

Selecting the USB Driver (USB Driver)

Refer to the "Switching USB Drivers" (p. 142)
Switching the USB Memory Mode
(USB Memory Mode)
Refer to the "Changing the USB Memory Setting" (p. 142)
Selecting the USB MIDI Thru Switch
(USB MIDI Thru Switch)
Refer to the "Using the RD-700GX as a USB MIDI Interface
(USB MIDI Thru Sw)" (p. 142)
Selecting the Function of the MIDI
THRU/OUT 3 Connector
(MIDI OUT3 Mode)
This setting specifies the function of the RD-700GX's MIDI
THRU/OUT 3 connector.
If you choose "OUT," the connector will function as MIDI OUT,
and will transmit data from the keyboard and controllers to an
external MIDI device.
If you choose "THRU," the connector will function as MIDI
THRU, retransmitting without change the MIDI messages that
are received at the MIDI IN connector. Performance data from
the RD-700GX itself will no longer be sent from this connector.
Parameter
MIDI OUT3 Mode
THRU, OUT
Value