Roland RD-700GX Owner's Manual page 163

35: OVERDRIVE
Creates a soft distortion similar to that produced by vacuum
tube amplifiers.
MFX Control Level, Amp Type, Drive, Pan
Parameter Value
Drive 0–127
SMALL,
BUILT-IN,
Amp Type
2-STACK,
3-STACK
Low Gain -15– +15 dB
High Gain -15– +15 dB
Pan L64–63R
Level 0–127
36: DISTORTION
Produces a more intense distortion than Overdrive. The
parameters are the same as for "35: OVERDRIVE."
37: VS OVRDRIVE (VS OVERDRIVE)
This is an overdrive that provides heavy distortion.
MFX Control Level, Tone, Amp Type, Drive, Pan
Parameter Value
Drive 0–127
Tone 0–127
Amp Sw OFF, ON
SMALL,
BUILT-IN,
Amp Type
2-STACK,
3-STACK
Low Gain -15– +15 dB
High Gain -15– +15 dB
Pan L64–63R
Level 0–127
38: VS DIST(VS DISTORTION)
This is a distortion effect that provides heavy distortion. The
parameters are the same as for "37: VS OVERDRIVE."
39: GTR AMP SIM
(GUITAR AMP SIMULATOR)
This is an effect that simulates the sound of a guitar amplifier.
MFX Control Pre Amp Master, Pre Amp Volume, Pre Amp, Speaker
Parameter Value
Pre Amp Sw OFF, ON
Assignable Parameters
Description
Degree of distortion
Also changes the volume.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Gain of the low range
Gain of the high range
Stereo location of the output sound
Output Level
Assignable Parameters
Description
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Type of guitar amp
SMALL: small amp
BUILT-IN: single-unit type amp
2-STACK: large double stack amp
3-STACK: large triple stack amp
Gain of the low range
Gain of the high range
Stereo location of the output sound
Output Level
Assignable Parameters
Description
Turns the amp switch on/off.
Parameter Value
JC-120,
CLEAN TWIN,
MATCH DRIVE,
BG LEAD,
MS1959I,
MS1959II,
MS1959I+II,
Pre Amp
SLDN LEAD,
METAL5150,
METAL LEAD,
OD-1,
OD-2 TURBO,
DISTORTION,
FUZZ
Pre Amp Volume 0–127
Pre Amp Master 0–127
LOW,
Pre Amp Gain MIDDLE,
HIGH
Pre Amp Bass
Pre Amp Middle
0–127
Pre Amp Treble
Pre Amp
0–127
Presence
Pre Amp Bright OFF, ON
Speaker Sw OFF, ON
(See the table
Speaker
below.)
Mic Setting 1, 2, 3
Mic Level 0–127
Direct Level 0–127
Pan L64–63R
Level 0–127
Specifications of each Speaker Type
The speaker column indicates the diameter of each speaker
unit (in inches) and the number of units.
Type Cabinet
SMALL 1 small open-back enclosure
SMALL 2 small open-back enclosure
MIDDLE open back enclosure
JC-120 open back enclosure
BUILT-IN 1 open back enclosure
BUILT-IN 2 open back enclosure
BUILT-IN 3 open back enclosure
BUILT-IN 4 open back enclosure
BUILT-IN 5 open back enclosure
BG STACK 1 sealed enclosure
BG STACK 2 large sealed enclosure
MS STACK 1 large sealed enclosure
MS STACK 2 large sealed enclosure
METAL STACK large double stack
2-STACK large double stack
3-STACK large triple stack
Effect/Parameter List
Description
Type of guitar amp
Volume and amount of distortion of the
amp
Volume of the entire pre-amp
Amount of pre-amp distortion
Tone of the bass/mid/treble
frequency range
Middle cannot be set if "Match Drive"
is selected as the Pre Amp Type.
Tone for the ultra-high frequency
range
Turning this "On" produces a sharper
and brighter sound.
This parameter applies to the "JC-
120," "Clean Twin," and "BG Lead"
Pre Amp Types.
Determines whether the signal passes
through the speaker (ON), or not
(OFF).
Type of speaker
Adjusts the location of the mic that's
capturing the sound of the speaker.
This can be adjusted in three steps,
from 1 to 3, with the mic becoming
more distant as the value increases.
Volume of the microphone
Volume of the direct sound
Stereo location of the output
Output level
Speaker Microphone
10 dynamic
10 dynamic
12 x 1 dynamic
12 x 2 dynamic
12 x 2 dynamic
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 2 condenser
12 x 4 condenser
12 x 4 condenser
12 x 4 condenser
12 x 4 condenser
12 x 4 condenser
163