Roland RD-700GX Owner's Manual page 159

Parameter Value
Speed SLOW, FAST
Wf Slow Rate 0.05–10.00 Hz
Wf Fast Rate 0.05–10.00 Hz
Woofer Accel 0–15
Wf Level 0–127
Tw Slow Rate 0.05–10.00 Hz
Tw Fast Rate 0.05–10.00 Hz
Tweeter Accel 0–15
Tweeter Level 0–127
Separation 0–127
Level 0–127
22: VK ROTARY
This type provides modified response for the rotary speaker,
with the low end boosted further.
This effect is a descendant of the Roland VK Series' built-in
rotary speaker.
MFX Control Speed, Brake, Tw Fast Rate, Wf Fast Rate
Parameter Value
Speed SLOW, FAST
Brake OFF, ON
Wf Slow Rate 0.05–10.00 Hz
Wf Fast Rate 0.05–10.00 Hz
Wf Trans Up 0–127
Wf Trans Down 0–127
Wf Level 0–127
Tw Slow Rate 0.05–10.00 Hz
Tw Fast Rate 0.05–10.00 Hz
Tw Trans Up 0–127
Tw Trans Down 0–127
Tweeter Level 0–127
Spread 0–10
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level 0–127
Description
Simultaneously switch the rotational
speed of the low frequency rotor and
high frequency rotor.
SLOW: Slows down the rotation to the
Slow Rate.
FAST: Speeds up the rotation to the
Fast Rate.
Slow speed (SLOW) of the low
frequency rotor
Fast speed (FAST) of the low frequency
rotor
Adjusts the time it takes the low
frequency rotor to reach the newly
selected speed when switching from
fast to slow (or slow to fast) speed.
Lower values will require longer times.
Volume of the low frequency rotor
Settings of the high frequency rotor
The parameters are the same as for
the low frequency rotor
Spatial dispersion of the sound
Output Level
Assignable Parameters
Description
Rotational speed of the rotating
speaker
Switches the rotation of the rotary
speaker.
When this is turned on, the rotation
will gradually stop. When it is turned
off, the rotation will gradually resume.
Low-speed rotation speed of the
woofer
High-speed rotation speed of the
woofer
Adjusts the rate at which the woofer
rotation speeds up when the rotation is
switched from Slow to Fast.
Adjusts the rate at which the woofer
rotation speeds up when the rotation is
switched from Fast to Slow.
Volume of the woofer
Settings of the tweeter
The parameters are the same as for
the woofer.
Sets the rotary speaker stereo image.
The higher the value set, the wider the
sound is spread out.
Gain of the low range
Gain of the high range
Output Level
23: CHORUS
This is a stereo chorus. A filter is provided so that you can
adjust the timbre of the chorus sound.
MFX Control Depth, Rate, Balance
Parameter Value
Filter Type OFF, LPF, HPF
Cutoff Freq 200–8000 Hz
Pre Delay 0.0–100.0 ms
Rate Mode Hz, note
Rate (Hz) 0.05–10.00 Hz
Rate ( ) note (*1)
Depth 0–127
Phase 0–180 deg
Low Gain -15– +15 dB
High Gain -15– +15 dB
D100:0W–
Balance
D0:100W
Level 0–127
24: FLANGER
This is a stereo flanger. (The LFO has the same phase for left
and right.) It produces a metallic resonance that rises and falls
like a jet airplane taking off or landing. A filter is provided so
that you can adjust the timbre of the flanged sound.
MFX Control Depth, Rate, Feedback, Balance
Parameter Value
OFF,
Filter Type LPF,
HPF
Cutoff Freq 200–8000 Hz
Pre Delay 0.0–100.0 ms
Rate Mode Hz, note
Rate (Hz) 0.05–10.00 Hz
Rate ( ) note (*1)
Depth 0–127
Phase 0–180 deg
Feedback -98– +98%
Low Gain -15– +15 dB
High Gain -15– +15 dB
D100:0W–
Balance
D0:100W
Level 0–127
Effect/Parameter List
Assignable Parameters
Description
Type of filter
OFF: No filter is used
LPF: Cuts the frequency range above
the Cutoff Freq
HPF: Cuts the frequency range below
the Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from the direct
sound until the chorus sound is heard.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of modulation (Hz)
Frequency of modulation (note)
Depth of modulation
Spatial spread of the sound
Gain of the low range
Gain of the high range
Volume balance between the direct
sound (D) and the chorus sound (W)
Output Level
Assignable Parameters
Description
Type of filter
OFF: No filter is used
LPF: Cuts the frequency range above
the Cutoff Freq
HPF: Cuts the frequency range below
the Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from when the
direct sound begins until the flanger
sound is heard.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of modulation (Hz)
Frequency of modulation (note)
Depth of modulation
Spatial spread of the sound
Adjusts the proportion of the flanger
sound that is fed back into the effect.
Negative (-) settings will invert the
phase.
Gain of the low range
Gain of the high range
Volume balance between the direct
sound (D) and the flanger sound (W)
Output Level
159