Synchronizing With An External Midi Device; Transmitting Synchronization Data - Roland Juno-Stage User Manual

Synchronizing with an External
MIDI Device
Connection Example
fig.midi-sync_e.eps
MIDI IN MIDI OUT
JUNO-STAGE
1. Press the [MENU].
2. Use [ ] [ ] to select "1. System" and press the [ENTER].
Press [4 (MIDI/SYNC)].
3.
4. Press [5 (SYNC)].
Use the cursor buttons to select the parameter you want to edit.
5.
6. Use the VALUE dial or [DEC] [INC] to edit the value.
Parameter Range
MASTER,
Sync
SLAVE,
Mode
REMOTE
Sync
OFF, ON
Output
Tempo
OFF, ON
Override
7. To save the settings, press [WRITE].
Chapter 7. Connecting an External MIDI Device
MIDI IN MIDI OUT
MIDI sequencer
Explanation
Specifies the signal according to
which the JUNO-STAGE will operate.
MASTER:
The JUNO-STAGE will be the master.
Choose this setting if you're using the
JUNO-STAGE on its own, without
synchronizing to another device.
SLAVE:
The JUNO-STAGE will be a slave
device. Choose this setting if you
want the JUNO-STAGE to operate
according to MIDI Clock messages
received from an external device.
REMOTE:
The JUNO-STAGE will obey Play,
Continue, and Stop MIDI messages
received from an external device,
but will operate according to its
own tempo setting.
If this is ON, synchronization-
related MIDI messages (MIDI Clock,
Start, Continue, Stop) will be
transmitted to the external MIDI
device.
If this is ON, the tempo will be
switched to the "Recommended
Tempo" setting of the performance
when you switch performances.

Transmitting Synchronization Data

If you want an external MIDI device to synchronize to the operation of
the JUNO-STAGE, make the following settings.
Parameter
Sync Mode
Sync Output
Value
MASTER
ON
91