Table of Contents
Advertisement
Getting Ready
Installing a Wave Expansion
Board
Two optional Wave Expansion Boards (SRX series; sold separately)
can be installed in the JUNO-STAGE.
Wave Expansion Boards store Wave data, patches, and rhythm sets,
and by equipping the JUNO-STAGE with these boards, you can
greatly expand your sound palette.
Cautions When Installing a Wave
Expansion Board
901
• To avoid the risk of damage to internal components that can be
caused by static electricity, please carefully observe the following
whenever you handle the board.
1
• Before you touch the board, always first grasp a metal object
(such as a water pipe), so you are sure that any static electricity
you might have been carrying has been discharged.
2
• When handling the board, grasp it only by its edges. Avoid
touching any of the electronic components or connectors.
• Use a Phillips screwdriver that is suitable for the size of the screw
(a number 2 screwdriver). If an unsuitable screwdriver is used, the
head of the screw may be stripped.
• To remove the screws, rotate the screwdriver counter-clockwise. To
tighten a screw, rotate the screwdriver clockwise.
fig.Screw.e
loosen
tighten
• When installing a Wave Expansion Board, remove only the
specified screw.
• Be careful that the screw you remove do not drop into the interior
of the JUNO-STAGE.
• Do not leave the bottom cover removed. After installation of the
Wave Expansion Board is complete, be sure to replace the cover.
• Be careful not to cut your hand on the edge of the cover or the
opening edge while removing the cover.
911
• Do not touch any of the printed circuit pathways or connection
terminals.
912
• Never use excessive force when installing a circuit board. If it
doesn't fit properly on the first attempt, remove the board and try
again.
913
• When circuit board installation is complete, double-check your
work.
18
How to Install a Wave Expansion Board
Install the Wave Expansion Board after removing the bottom panel
cover.
1.
Before installing the Wave Expansion Board, turn off the power of
the JUNO-STAGE and all connected devices, and disconnect all
cables, including the AC adaptor, from the JUNO-STAGE.
2.
From the JUNO-STAGE, remove only the screw shown in the
following diagram, and detach the cover.
fig.Exp1.e
JUNO-STAGE : bottom
Screw to be removed
928
When turning the unit upside-down, get a bunch of newspapers
or magazines, and place them under the four corners or at both
ends to prevent damage to the buttons and controls. Also, you
should try to orient the unit so no buttons or controls get
damaged.
929
When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
fig.Exp2
3.
As shown in the following illustration, plug the connector of the
Wave Expansion Board into the connector of the relevant slot,
and at the same time insert the board holder through the hole of
the Wave Expansion Board.
fig.Exp3.e
Board holder
Position it as shown
before you install
the board.
Connector
Advertisement
Table of Contents
