Table of Contents
Advertisement
V-LINK Settings (V-LINK SETUP)
1.
Press [V-LINK] to access the V-LINK screen.
2.
Press [7 (SETUP)].
The V-LINK SETUP screen appears.
fig.V-LINK-SETUP
3.
Use [
] [
] to move the cursor to the parameter you want to
edit.
4.
Use the VALUE dial or [DEC] [INC] to set the value.
Parameter
Value
Note Tx
Channel A
Note Tx
1–16
Channel B
Note Tx
Channel C
Assigns a V-LINK function to the D Beam
controller.
OFF
ColorEQ Fore
ColorEQ Back
Scratch SW
Speed Knob
Total Fader
Cross Fader
BPM Sync SW
Clip Loop SW
Assign Knob
Fade Time SW
D BEAM
Visual Knob
AB SW
Tap SW
Total Select
FX Select
Play Pos
LoopStartPos
Loop End Pos
LayerModeSel
Dissolve Time
Color Cb Ctrl
Color Cr Ctrl
Brightness Ctrl
VFX1 Ctrl
VFX2 Ctrl
VFX3 Ctrl
VFX4 Ctrl
Fade Ctrl
Explanation
Controls the V-LINK
device. Specify the
MIDI channel. (*)
The operation
selected by D BEAM
buttons will occur
regardless of
whether V-LINK is on
or off.
CC01 (Modulation)
CC71 (Resonance)
CC03
CC08 (Balance)
CC10 (Panpot)
CC11 (Expression)
CC64 (Hold)
CC65 (Portamento)
Used with
CC72 (Release)
motion dive
CC73 (Attack)
.tokyo
Performance
CC74 (Cutoff)
Package
CC81 (General-6)
CC83 (General-8)
CC85
CC86
CC91 (Reverb)
CC92 (Tremolo)
CC93 (Chorus)
CC94 (Celeste)
CC73 (Attack)
CC01 (Modulation)
CC71 (Resonance)
CC74 (Cutoff)
Used with the
CC72 (Release)
DV-7PR and
similar devices.
CC91 (Reverb)
CC92 (Tremolo)
CC93 (Chorus)
CC10 (Panpot)
Chapter 3. Versatile Performance Functions
* :
On V-LINK compatible devices such as the Edirol DV-7PR/P-1,
only Note Tx Channel A is used.
In motion dive .tokyo Performance Package, the Note Tx Channel
corresponds as follows.
A: The MIDI channel that controls section A
B: The MIDI channel that controls section B
C: The MIDI channel that controls the MIDI note plug-in
5.
If you want to keep your settings, press [7 (WRITE)].
Press [6 (EXIT)] or [EXIT] to return to the previous screen.
6.
67
Advertisement
Table of Contents
