Roland Juno-Stage User Manual page 136

Chapter 10. Detailed Editing for Performances
CTRL SETTING (PERF) Parameters
[2 (TEMPO)]
Parameter Value
Recommended
20–250
Tempo
[3 (S1/S2)]
Specifies the functions that will be controlled by the [S1] and [S2] buttons.
Parameter Value
Switch 1/Switch 2
TRANSPOSE UP
TRANSPOSE DOWN
TAP TEMPO
MONO/POLY
PORTAMENTO
HOLD
Assign
MFX1–3 SW
CHORUS SW
REVERB SW
SYS CTRL 1–4 SRC
BEND MODE
PART 1–16 KBD SW
LATCH
Type
MOMENTARY
[4 (DBASGN)]
Specifies the function that will be controlled by the D Beam controller when D BEAM [ASSIGNABLE] is on.
Parameter Value
CC01–31, 33–95
BEND UP
BEND DOWN
START/STOP
TAP TEMPO
ARP GRID
Type
ARP DURATION
ARP MOTIF
ARP OCTAVE UP
ARP OCTAVE DOWN
ARP STEP
AFTERTOUCH
Range Min 0–127
Range Max
0–127
136
Explanation
If the JUNO-STAGE's tempo is to change when you switch performances, this setting specifies the
tempo. In order to enable this setting, you must turn on the System setting "Tempo Override" (p. 151).
Explanation
Shift the pitch of the keyboard upward in semitone steps (a maximum of six semitones).
Shift the pitch of the keyboard downward in semitone steps (a maximum of five semitones).
Used to set the tempo to the interval at which you press the button.
Specify whether the patch will play polyphonically (POLY) or monophonically (MONO).
Turn the Portamento on/off.
Turn the Hold on/off.
Switch the multi-effects 1–3 on/off.
Switch the chorus on/off.
Switch the reverb on/off.
Transmit the MIDI message specified by the System setting "Sys Ctrl 1–4 Source" (p. 148).
Switches the bend mode (p. 146)
The mode will be "Normal" when the button is off, and "CATCH+LAST" when the button is on.
Turns the keyboard switch (p. 134) on/off for the specified part
The on/off status will alternate each time you press the button.
The assigned function will turn on while you press the button, and will turn off when you release it.
Explanation
Controller number 1–31, 33–95
Control the pitch change specified by the Pitch Bend Range Up (p. 101) setting.
Control the pitch change specified by the Pitch Bend Range Down (p. 101) setting.
Start/stop the song or the rhythm pattern.
Specify the tempo according to the interval at which you position your hand over the D Beam (tap tempo).
Specify the time signature and swing of the arpeggio.
Specify the duration for each note of the arpeggio.
Change the upward/downward variation of the arpeggio.
Shift the arpeggio's octave upward (maximum of three octaves)
Shift the arpeggio's octave downward (maximum of three octaves)
Control the playback position of the arpeggio pattern.
Aftertouch
Specifies the lower limit of the D Beam controller's range.
There will be no effect if the position of your hand above the D
Beam controller is higher than this setting.
Specifies the upper limit of the D Beam controller's range.
There will be no effect if the position of your hand above the D
Beam controller is lower than this setting.
* If Range Max is lower than Range Min, the range of variation
will be vertically inverted.
0
Range Min
Range Max
127