Roland Juno-Stage User Manual page 153

Roland juno-stage: user guide
Table of Contents

Advertisement

[4 (ATV EXP)]
Parameter
Value
Range Min
0–127
Range Max
0–127
[5 (ASSIGN)]
Parameter
Value
CC01–31, 33–95,
BEND UP,
BEND DOWN,
START/STOP,
TAP TEMPO,
ARP GRID,
Type
ARP DURATION,
ARP MOTIF,
ARP OCTAVE UP,
ARP OCTAVE DOWN,
ARP STEP,
AFTERTOUCH
Range Min
0–127
Range Max
0–127
Explanation
Lower limit of the range of the Active Expression.
The effect will be applied when the position of your hand
above the D Beam controller is lower than this value.
Upper limit of the range of the Active Expression.
The effect will be applied when the position of your hand
above the D Beam controller is above this value.
* By setting Range Max below Range Min you can invert the
range of change.
Explanation
Function controlled by the D Beam controller
CC01–31, 33–95: Controller numbers 1–31, 33–95
BEND UP: Controls the pitch as specified by the "Pitch Bend Range Up" setting (p. 101).
BEND DOWN: Controls the pitch as specified by the "Pitch Bend Range Down" setting (p. 101).
START/STOP: Starts/stops the song or rhythm pattern.
TAP TEMPO: Tap tempo (a tempo specified by the interval at which you move your hand over
the D Beam controller).
ARP GRID: Specifies the arpeggio's time signature and swing
ARP DURATION: Duration of each arpeggiated note
ARP MOTIF: Ascending/descending arpeggio variation
ARP OCTAVE UP: The range in which the arpeggio is sounded will rise in steps of an octave
(maximum 3 octaves).
ARP OCTAVE DOWN: The range in which the arpeggio is sounded will lower in steps of an
octave (maximum 3 octaves).
ARP STEP: Control the playback position within the arpeggio pattern.
AFTERTOUCH: Produce the same effect as aftertouch.
Lower limit of the range of the D Beam controller.
The effect will be applied when the position of your hand above the D Beam controller is lower
than this value.
Upper limit of the range of the D Beam controller.
The effect will be applied when the position of your hand above the D Beam controller is above
this value.
* By setting Range Max below Range Min you can invert the range of change.
Chapter 11. Other Settings
Range Min
Range Max
0
127
153

Advertisement

Table of Contents
loading

Table of Contents