List Of Parameters - Infrico Lab Care Plus ULF70086 Service Manual

8.7

List of Parameters

PARAM. V.DEFECT MIN.
A01 -10
A02 10
A03 300
A04 60
A05 -20
A06 45
A07 0
A08 0
A09 0
PARAM. DEFECTO MIN.
D01 0
D02 1
D03 1
D06 -
D07 1
D08 5
MAX. M.U.
Differential of alarm of low temperature in camera (relative to
-50 0 ºC/ºF
0 50 ºC/ºF Differential of alarm of high temperature (relative to setpoint)
Retardation of alarm of discharge and low temperature from
0 300 min
0 900 min
Minimum allowable evaporator temperature (relative to set
-50 0 ºC/ºF
0 90 ºC/ºF
0 60 ºC/ºF
0 20 ºC/ºF
0 20 ºC/ºF
MAX. M.U.
Temperature measurement unit
0 1 --- 0 = Celsius
1 = Fahrenheit
Display of the initial screen of welcome
0 1 --- 0 = none
1 = INFRICO
Backlight
0 = ignited pressing any key, after minto, the bottom light is
0 1 ---
extinguished and only key HOME is illuminated.
1 = Always ignited.
Blockade of screen of the temperature of camera during
defrost.
0 1 ---
0 = no blocking
1 = enabled
1 300 min Time out for keyboard lock
Keyboard lock
0 = no authorised
0 2 --- 1 = blockade/unfreezing allowed by key
2 = lock activated per time of delay or key, opening allowed
by key
Service Manual and Warranty
ALARMS
setpoint)
the ignition of the device or finalized defrost
Alarm delay high and low temperature.
Maximum allowable condenser temperature (relative to set
Temperature differencial for dirty condenser alarm
Low temperature alarm hysteresis (relative to A01)
High temperature alarm hysteresis (relative to A02)
ALARMS
31
point)
point)