Infrico Lab Care Plus ULF70086 Service Manual page 29

After a few seconds, an overview screen will display the current calibration values and probe
temperature.
During calibration, it is possible to return and calibrate a point whose value has already been set. If a new
calibration is required, the procedure should be performed again from the start by pressing ESC and returning to
the desired probe selection screen. If a calibration has already been performed, an overview screen will be
displayed when enabling calibration mode.
If you wish to modify the calibration, press the
To enter the product probe calibration mode, press the
described for the chamber probe.
Service Manual and Warranty
key and repeat the procedure.
key and follow the instructions
28