Kyocera Mita Ecosys FS-1800+ Operation Manual page 54

Using the Operator Panel
MENU
ENTER
ENTER
Changing Serial Interface Modes
You can set the baud rate, data bits, stop bits, parity, and protocol for the
serial interface.
1
Press the MENU key.
2
Press the or
of the interface names shown below appears, indicating the current
interface.
Parallel (default)
Serial
Option (when a network interface card is installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the or
Interface
? Serial
5
Press the ENTER key again.
key repeatedly until Interface > appears. One
key repeatedly until Serial appears.
1-42