Kyocera Mita Ecosys FS-1800+ Operation Manual page 69

>Size
MENU
?
ENTER
ENTER
MENU
Changing the Font Size
You can change the size of the default font. If the default font is a fixed font
such as Courier or Letter Gothic, the character pitch can be changed
instead of the font size.
1
Press the MENU key.
2
Press the or
Font
Internal
3
Check that Internal is displayed and press the > key.
4
Press the or
>Size
012.00 point(s)
5
Press the ENTER key. A blinking cursor ( _ ) appears.
>Size
012.00 point(s)
6
Press the or
where the cursor is blinking. The font size can be set between 4 and
999.75 points, in 0.25-point increments. You can use the > or < key to
move the cursor right and left.
If you want to abandon the setting procedure, press the CANCEL
key.
7
When the desired size is displayed, press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
key repeatedly until Font > appears.
>
key repeatedly until >Size appears.
key to increase or decrease the value of the figure
1-57
Using the Operator Panel