Kyocera Mita Ecosys FS-1800+ Operation Manual page 60

Using the Operator Panel
Option
MENU
ENTER
ENTER
Printing a Network Card Interface Status Page
To use this function, the network interface card must be installed on the
printer.
You can print out a status page for the network interface. The network
interface card status page shows the firmware version, the network
addresses, and other information under various network protocols about
the network interface card. The default setting is Off (not print). If the
setting is changed to On (print) as follows, however, the network interface
status page will be printed when the printer status page is printed.
Printing out a network interface card status page may not be possible
with some network interface cards. For details, see the manual for the
network interface card.
Note
1
Press the MENU key.
2
Press the
Interface
Parallel
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
If you want to abandon the interface selection procedure, press the
CANCEL key. The interface remains unchanged.
4
Press the
Interface
? Option
5
Press the ENTER key again. A > appears.
Interface
Option
or key repeatedly until Interface > appears.
>
or key repeatedly until Option appears.
>
1-48