Kyocera Mita Ecosys FS-1800+ Operation Manual page 99

1
MENU
2
3
ENTER
4
?
5
ENTER
6
ENTER
7
MENU
Press the MENU key.
Press the or key repeatedly until RAM Disk Mode > appears.
RAM Disk Mode
Off
The default setting is Off. Press the ENTER key. A blinking question
mark (?) appears. Select On using the
the ENTER key.
RAM Disk Mode
? On
Press the > key to display >RAM Disk Size.
>RAM Disk Size
## Mbyte
Press the ENTER key again, and change the RAM disk size using the
or key. It is not possible to make a setting that exceeds total
printer memory. The default value for the RAM disk is the total
printer memory minus 9 MB. This parameter may be set anywhere
from 01 to 99 depending on the available printer memory.
If you want to abandon the setting, press the CANCEL key.
When the desired RAM disk size is displayed, press the ENTER key.
Press the MENU key and restart the printer. The setting will be
activated after restart.
1-87
Using the Operator Panel
or key, and then press