Removing And Installing An Optane Memory Module - HP Z1 Entry Tower G5 Maintenance And Service Manual

Removing and installing an Optane memory module

IMPORTANT:
replacing the module, be sure to install the new module in the same connector as the old module.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power and data cables from the rear of the drives in the drive cage.
5. Rotate the drive cage up (see
6. To remove an Optane memory module, remove the Phillips screw (1), and then pull the Optane memory
module away from the connector (2).
7. To install an Optane memory module, insert the new module into the connector (1), and then install the
screw (2).
8. Rotate the drive cage down (see
9. Connect the power and data cables to the rear of the drives in the drive cage.
10. Reassemble the computer.
44 Chapter 4 Removal and replacement procedures
An Optane memory module can be installed in either M.2 connector on the system board. If
(Access panel on page
(Front bezel on page
Drive cage on page
Drive cage on page
(Preparation for disassembly on page
18)
19).
27)
27)
17)