Installing A Flash Memory Module - HP t610 Series Troubleshooting Manual

Flexible thin clients

Hide thumbs Also See for t610 Series:

Table of Contents

Insert the tab on the front edge of the access plate into its slot (1) and press the plate down

lightly to engage the latch (2).

Figure 2-11

Slide the serial number tab back to its original position.

Installing a flash memory module

Before beginning the installation process, review

for procedures you should follow before and after installing or replacing hardware.

WARNING!

side access panel, ensure that the thin client is turned off and the power cord is disconnected from

the electrical outlet.

CAUTION:

cards. Before beginning these procedures, ensure that you are discharged of static electricity by

briefly touching a grounded metal object. When handling a memory module, be careful not to touch

any of the contacts. Doing so may damage the module.

To install the flash memory module:

If an internal hard drive is installed, remove it. See

for instructions.

Replacing the SODIMM access plate

You must remove the left side panel to access the system board. Before removing the

Static electricity can damage the electronic components of the computer or optional

General hardware installation sequence on page 9

Removing an internal hard drive on page 21

Installing thin client options

Table of Contents

Show Quick Links

Table of Contents