HP Kayak XW A2-U2-W2 User Manual page 65

Completing the
Installation of a
Processor
NOTE
NOTE
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus speed
and processor speed. Refer to the manual supplied with the processor
to verify which bus and processor speeds are supported.
Switch 1 Switch 2
1
UP DOWN
UP DOWN
UP DOWN
UP DOWN
1. UP=OFF, DOWN=ON.
2 Install any other accessories before completing the installation of the
processor.
3 Replace the cover (see page 23).
4 Turn on the computer and check that the new processor is
recognized by the power-on system-test.
To fully benefit from dual processing, you will need to re-install
Windows NT 4.0 on your PC Workstation.
2 How to Install Accessories Inside Your PC Workstation
Switch 3 Switch 4
DOWN UP
UP DOWN
UP DOWN
UP UP
Installing a Processor
Switch 5 Bus
Speed
UP 66 MHz
DOWN 66 MHz
UP 66 MHz
DOWN 66 MHz
Processor
Speed
233 MHz
266 MHz
300 MHz
333 MHz
English 51