If You Can't Start the Setup Program
This may happen if the copy of the PC Workstation's configuration
stored in memory is corrupted. You will need to erase this bad
configuration.
To clear the configuration:
1 Switch off the PC Workstation and remove the cover ( see refer to
"Removing the Cover" on page 23).
2 Set the system board switch 6 (CONFG) on the switch block DOWN
to clear the configuration (refer to page page 90 for the switch
location).
3 Replace the cover and switch on the PC Workstation to erase the
memory.
4 Check that error codes
the PC Workstation has started.
5 Switch off the PC Workstation and remove the cover.
6 Set the system board switch 6 (CONFG) on the switch block to OFF
to re-enable the configuration.
7 Replace the cover (see refer to "Replacing the Cover" on page 25).
8 Switch on the PC Workstation and run Setup by pressing
appears. (Error code
Setup
PC Workstation starts.)
9
Press
to save the configuration and exit from Setup.
If the Date and Time Are Incorrect
The date and time can be incorrect for the following reasons:
The time has changed to reflect the beginning or end of Summer
•
Time
The PC Workstation has been unplugged from the mains for too long
•
and the battery is discharged.
The on-board battery automatically recharges itself as soon as the
PC Workstation is plugged into a power outlet.
3 Troubleshooting Your PC Workstation
If Your PC Workstation Has a Software Problem
and
are displayed, and wait until
0240
0130
will appear when the
0130
when
English
69