HP Kayak XW A2-U2-W2 User Manual page 114

Configure/View
Interface Settings Menu
4 Technical Information
Configuring a SCSI Accessory Using SCSISelect
It is recommended that you do not change these settings.
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID . . . . . . . . . . . . . . 7
SCSI Parity Checking . . . . . . . . . . . . . . Enabled
Additional Options
Boot Device Options
SCSI Device Configuration
Advanced Configuration Options . . . . . . . . . Press <Enter>
<F6> - Reset to Host Adapter Defaults
BIOS Information
Interrupt (IRQ) Channel . . . . . . . . . . . . . . 15
I/O Port Address
SCSI Channel Interface Definitions:
• Host Adapter SCSI ID
Changes the adapter SCSI ID from its default value of 7 (which has
the highest priority on the SCSI bus).
• SCSI Parity Checking
Enable or disable host adapter SCSI parity checking. Most currently
available SCSI devices do support SCSI parity. You should disable
SCSI Parity Checking if any of the attached SCSI devices do not
support SCSI parity.
Additional Options:
• Boot Device Options
Press to display the Boot Device Configuration menu,
described on the next page.
• SCSI Device Configuration
Press to display the SCSI Device Configuration menu.
100 English
SCSISelect(TM) Utility v1.xxx
. . . . . . . . . . . . . . Press <Enter>
. . . . . . . . . . . Press <Enter>
. . . . . . . . . . . . . . . . . F800h