Installing An External Battery - HP Kayak XW A2-U2-W2 User Manual

WARNING

Installing an External Battery

There is a danger of explosion if the battery is incorrectly installed. For
your safety, never attempt to recharge, disassemble, or burn the old
battery. Replace the battery only with the same or equivalent type
recommended by the manufacturer. The battery is a lithium battery
which does not contain heavy metals; nevertheless, in order to protect
the environment, do not dispose of the batteries in household waste.
Please return used batteries to the shop from which you bought them,
to the dealer from whom you purchased the PC, or to Hewlett Packard,
so that they can either be recycled or disposed of in an environmentally
sound way. Returned used batteries will be accepted free of charge.
If the installed battery stops working, you can install an external
battery in the PC Workstation. You can order this from your
HP-authorized reseller.
The battery is not covered by the HP Warranty.
Install the external battery as follows:
1 After removing the computer's cover, connect the external battery
cable to the battery connector on the system board (see page 90 for
the location of the external battery connector on the system board).
2 Mount the external battery to the upper disk drive support using the
self-adhesive strip supplied.
After installing an external battery, replace the computer's cover and
run the HP Setup program to reconfigure the computer.
3 Troubleshooting Your PC Workstation
Installing an External Battery
English 71